Penn Senator Reel Handle Replacement Tutorial

0 comments

If you're an avid angler, then you know how important it is to have a reliable fishing reel. Unfortunately, even the best reels can break down over time, and one of the most common issues is a broken or damaged reel handle. A broken handle can make reeling in your catch difficult, if not impossible, and it can ruin your entire fishing trip.

Fortunately, replacing a Penn Senator reel handle is a relatively easy task that can be done by anyone with a little bit of know-how. In this article, we'll provide a step-by-step tutorial on how to replace the handle on your Penn Senator reel, as well as some helpful tips to ensure success.

Step One: Remove the Old Handle

The first step in replacing your Penn Senator reel handle is to remove the old one. To do this, you will need a screwdriver. Start by locating the screw that attaches the handle to the reel body. This screw may be located on the side of the reel or underneath the handle itself.

Once you've located the screw, use the screwdriver to unscrew it from the reel body. Be careful not to damage any of the internal parts while removing the screw. Once the screw is removed, the handle should come off easily.

Step Two: Prepare the New Handle

Before installing the new handle, you need to make sure that it's the correct replacement part for your Penn Senator reel. You can find this information in your reel's owner's manual or by contacting the manufacturer directly.

Assuming that you have the correct replacement part, it's time to prepare the new handle for installation. Apply a small amount of oil or grease to the threads of the new handle. This will prevent corrosion and make future removal easier.

Step Three: Install the New Handle

With the new handle prepared, it's time to install it onto the reel. Place the handle onto the reel body and carefully screw it into place. Make sure the handle is tightened securely, but don't overtighten it as this could damage the reel.

Step Four: Test the New Handle

To ensure that the new handle is properly installed, test it by turning the reel handle. If the handle turns smoothly and without issue, then you're good to go. However, if there are any issues, take the handle off and start the process again.

Additional Tips

While replacing a Penn Senator reel handle is a relatively straightforward task, there are some additional tips that can help ensure your success.

Check Compatibility

Before ordering a replacement handle, it's always a good idea to double-check the compatibility of the replacement handle with your specific Penn Senator reel model. Not all handles are compatible with all reels, so make sure that the handle you order is the correct one for your reel.

Keep Track of Washers and Spacers

When removing the old handle, keep track of any washers or spacers that may have been used. These small parts can easily be lost during the removal process, and they are important for ensuring proper operation of the reel. Make sure that you reinstall any washers or spacers in the correct order when installing the new handle.

Be Gentle

Always be gentle when handling the reel and its internal components. Fishing reels are delicate instruments that can be easily damaged if they are mishandled. Avoid using excessive force when removing or installing the handle, and be careful not to damage any other parts of the reel during the process.

Conclusion

Replacing the handle on a Penn Senator reel may seem like a daunting task, but it is actually a simple process that any angler can tackle with the right tools and a little bit of knowledge. Following these steps carefully will help ensure that you replace the handle properly and without causing any damage to your reel. By having a properly functioning reel, you can ensure that you have the best chances of catching fish and enjoying your time on the water.

Leave a comment

All blog comments are checked prior to publishing
You have successfully subscribed!
This email has been registered